SBR front button and LED
From SqueezeboxWiki
(Redirected from SBRFrontButtonAndLED)
The Squeezebox Receiver has one button with a TricolorLED behind it.
Button usage
- To put Squeezebox Receiver into setup mode, press and hold the button for about 3 seconds or until it blinks slow red then release it.
- To do a factory reset on Squeezebox Receiver, continue holding for a total of 6 seconds until it starts blinking fast red. Release and after factory reset, it will start flashing slower and be ready to set up.
- If you press and hold the button while plugging in the Receiver, you'll see the button sequence through a series of colors and a set of ascending test tones will be played through the audio outputs.
- When connected to Squeezebox Server or MySqueezebox.com the button is WHITE, press to pause the music. Press again to start the music up again.
- While music plays the button is bright white; when paused it is dark white.
Color codes
LED color | Meaning | |
Red (solid) | Booting up | |
Red (blinking slow) | Awaiting to be setup | |
Yellow | Waiting for wireless to connect / Link down on ethernet | |
Green | Network connected, waiting for DHCP to get IP address (skipped when using static IP) | |
Blue | Waiting to connect to Squeezebox Server or MySqueezebox.com | |
White | Connected to Squeezebox Server or MySqueezebox.com | |
White (blinking fast) | Firmware update in progress | |
Red (blinking fast) | Factory Reset and xilinx update in progress | |
Purple | Hard error with blink codes, a number of blinks with a one second pause in between (Note: The white light might have a purplish tint. If it's not blinking, everything is normal.) |
Hard error codes
Number of blinks | Meaning |
1 blink | MAC address missing/bad (checked second upon boot-up) |
2 blinks | Wireless card missing/bad (checked first upon boot-up) |
3 blinks | SNV failure/error |
4 blinks | Upgrade error |
5 blinks | CPLD XSVF file open error (xilinx file) |
6 blinks | UUID not set/all zeros (Checked third upon boot-up) |